Register    Login    Forum    FAQ    PinSimDB.org

Board index » Resources » FPM EDITOR and 3D models




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: help needed
 Post Posted: Wed Nov 21, 2018 5:44 pm 
Offline
User avatar

Joined: Thu Jan 26, 2017 6:48 pm
Posts: 51
Location: Australia
I have successfully imported a model into milkshape, exported it as an MS3D file and imported it into FPM Editor and saved as a bumper cap model but when I try to use the model in FP it is too high. How can I offset it lower?


You do not have the required permissions to view the files attached to this post.


Top 
 Profile  
 
 Post subject: Re: help needed
 Post Posted: Wed Nov 21, 2018 11:24 pm 
Offline
User avatar

Joined: Thu Jan 26, 2017 6:48 pm
Posts: 51
Location: Australia
never mind, worked out how to do it in milkshake


Top 
 Profile  
 
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 2 posts ] 

Board index » Resources » FPM EDITOR and 3D models


Who is online

Users browsing this forum: No registered users and 1 guest

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: